Mr Anwar ceramic tile cutting, rounding of rendering

When decorate, a lot of times we will be asked Mr Anwar renderings of ceramic tile cutting explanation, what about Mr Anwar ceramic tile cutting, rounding of rendering, how should we do when selecting a decorate a company to decorate choice, just to tell you about questions about Mr Anwar ceramic tile cutting, rounding of rendering. Note 1 cutting ceramic tile, uniform line should be from beginning to end, continuous and clear; Knife roller is made due to the special hard alloy, therefore, as long as you hold the handle with a small force, easy and fluent wheel can draw a cutting line to push the edge of the sword; In the process of cutting ceramic tile, the strength is not on the line, exert oneself to do STH. Overly line will make the tangent sawtooth, shorten the service life of knife wheel normal; 2, cutting vitrified tile and tile is different of the saw blade, saw blade is not also easy froe vertical edge, cut ceramics is to fine sand saw blades, machine instability uneven or vibration will lead to froe edge. Driving force must light, ceramic tile cutting mark line as above, otherwise there will be ceramic tile and Angle phenomenon. Positioning, one hand holding the tile cutter handle, pull sliding seat to the back seat, put the flat floor, ceramic tile at first to live bottom gap; Line, put down the handle knife wheel in contact with the surface of ceramic tile, handle nudge forward make knife wheel in ceramic tile surface cut out continuous uniform linear; Down, will handle is raised slightly back, with the proper force to press the lever, ceramic tile will be along the line disconnected; Without tools for cutting ceramic tile method first, move selected cutting size scale, with one hand holding the operating handle, pull a knife round to the back seat, put the ceramic tile is flat on the floor and ceramic tile cutting line and floor beam alignment, ceramic tile front end to live bottom gouges where whole pieces were missing. Then, put down the handle knife wheel in contact with the surface of ceramic tile, will handle nudge forward make knife wheel in ceramic tile surface a continuous uniform linear cutting machine. Finally, to raise the operating handle pulled back slightly, drop pressure piece of smooth on the front end of ceramic tile. With the proper force to press the operating handle, ceramic tile along the line will be disconnected. Above is the small make up for everyone to sort out some information about the anwar ceramic tile cutting, rounding of rendering, hope these data can help to you, also hope you can read the above information, avoid the mistakes when decorate.
Clouds of ceramic floor tile failures surround the world of ceramic floor tile in particular, simply because people don’t pay as much attention to the tile company as they should do.
We humbly ask you to use tile company and we guarantee that you would be in a great delight with using the product.
Time is one of the biggest challenges cited by manufacturing tile company.